6007 Nachi Bearing Open C3 Japan 35x62x14 Ball Bearings

Just what I needed to balance the front tire on our Ninja 250R motorcycle. The axle is specified as 15mm OD and these 15mm ID bearings fit just fine over the end thread and axle. We suspend the tire on the axle with a bearing on both ends on jack stands on either side of the tire. The bearings are very sensitive. Works great and saved about $50 on balancing a tire. I store these open sided bearings in a jar of motor oil for next time. Cost of bearings were very reasonable compared to others I have seen. Happy with purchase.

Just what I needed to balance the rear tire on our Ninja 250R motorcycle. The axle is specified as 17mm OD and these 17mm ID bearings fit just fine over the end thread and axle. We suspend the tire on the axle with a bearing on both ends on jack stands on either side of the tire. The bearings are very sensitive. Works great and saved about $50 on balancing a tire. I store these open sided bearings in a jar of motor oil for next time. Cost of bearings were very reasonable compared to others I have seen. Happy with purchase.

Excellent quality. Can't complain.

I needed a new throw out bearing for my 1979 Honda CX500. Honda lists the bearing as obsolete. I know that this bearing is just a basic 6000 bearing, so I searched elsewhere and ended up at Amazon. I am familiar with Nachis' quality and this one was to their standards.